Polaris Brutus Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi guys,
The Brutus didn't really sell very well in the uk for several reasons, however it is the perfect machine for my business and I was lucky enough to get one last year as Polaris uk had one still in the crate from 2013.
It was a Brutus HD with the Yanmar engine, and I had the pto fitted afterwards. I use it with the Polaris rotary mower, front forks and a bucket.
I found this forum last week as I need to service it and I could get all the parts except for the hydraulic oil, so I need to know what you would use if you don't buy the Polaris hydraulic oil, as I couldn't find a spec anywhere?
Also are there any upgrades I need to know about? I've read a bit about the HT Spring and my dealer has ordered me the newer version, but is there anything else?
Also what is the top speed and rpm should I be looking at when idling? It's a bit sluggish, which I expect from a hydrostatic, but just want to make sure its operating where it needs to be.
Anything you can tell me to look out for would be greatly appreciated as I need to keep it for a long time!
Many thanks,
Tony
 

· Registered
Joined
·
80 Posts
Hi Tony, Pls check my posts for several answers.

SuperTech heavy duty R&O anti-wear hydraulic oil from Walmart is just fine.

Per spec 1250rpm is min and 3800rpm is Max, high range speed on level suface should be 30mph per spec.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top