Polaris Brutus Forum banner
1 - 1 of 1 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
I don't know how many of you are like me, but I have decimated the factory wheel yokes on my mower deck. I've spent hours on the anvil beating the wheel yokes back in place, and I finally got sick of that. As such, I made these beefed up wheel yokes out of 3/8 plate. The attached picture shows the difference between the new yoke and the old yoke. So far I have not bent any of these new wheel yokes. You'll need to use your existing wheel and mounting hardware. $275/each


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.